We cut the doorway. You walk through it.

What wall sawing is

A wall saw runs a diamond blade along a track bolted to the wall, so the cut is perfectly straight and the depth is controlled to the inch. It cuts where a hand saw can't reach the thickness and a demolition hammer would leave a ragged edge.

Typical jobs

• Door and window openings in foundations and tilt-up panels
• HVAC, duct and pipe penetrations
• Stair and elevator openings
• Expansion joints and partial wall removals

How NoCo does it

We GPR-scan the wall first, lay out the opening with you, and cut with water control and dust management in place. Overcuts are avoided with a chainsaw finish at the corners when the job calls for it. When the piece is removed, the edges are square and ready for framing or finish.

Every job starts with a scan

Every NoCo job starts the same way. We scan the slab or wall with ground penetrating radar to map rebar, post-tension cables, conduit and voids. Then we choose the right tool — a track-mounted wall saw for openings, a rig-mounted core drill for round penetrations, a walk-behind flat saw for slabs and pavement — and cut once, straight and to depth. When we open something up, our pour-back service can close it again with concrete matched to the surrounding grade and finish.

Who we work for

General contractors and builders who need openings cut on schedule. Plumbers, electricians and HVAC contractors who need clean penetrations without collateral damage. Property owners and managers modifying an existing building. Homeowners adding a basement window or a new door. Municipal and commercial crews cutting roads and slabs. Residential or commercial, one hole or a whole floor — the standard is the same.

Where we work

Fort Collins, Loveland, Greeley, Windsor, Longmont, Denver and the surrounding Northern Colorado communities, plus projects across Wyoming. If you're not sure you're in range, ask — we travel for the right job.